Hot Product

Product drawing»

Structural drawing»

You are here: News > News Detail

Pre-turbocharger methanol injection

2010-11-30

I am trying to understand what the limits are of pre-compressor methanol injection on turbocharged cars.

From my understanding, erosion occurs when you have the wrong combination of compressor speed and droplet size.

I have a turbocharger and I calculated the tip speed of the compressor to be at about 1158 ft/s at maximum boost.

My question is if the inlet tubing to the compressor is 3 feet long and I am flowing 100 ml/min of pure methanol (tiny amounts) will I see erosion if my ambient inlet temps are 80 degrees F?

I did a quick hand calc and the speed the air is moving through the inlet tube is about 160 ft/s so it will take about 20 ms for the air to reach the compressor.

I dont know how to compute the content of liquid left in this mixture, the methanol is injected via a super atomizing nozzle. So inlet droplet size can be assumed some value. I just dont know droplet size at the end of the tube feeding the compressor.

Why would you want to inject at pre-compressor stage? The higher the temperature difference, the more efficeint cooling will be. I can see a case where you'd argue to inject before any intercooler, to use that gain, but not before the compressor.

In general, methanol is injected either directly into the cylinders or into the inlet ports of the engine, when used as "regular" fuel. This does prevent most effects of long term corrosion. When risking the chance of condensation of your methanol onto the compressor wheel, intercooler and inlet tract, you will probably expose your aluminium much more than when injecting further towards the inlet valves.

I don't think that experimenting with the size and concentration of the droplets will make a fundamental difference. Maybe a practical, but you're still exposing aluminium to (heated) methanol. It will corrode in the end. I don't know if cavitation plays a part in this process, but purely chemical, concentration and temperature are your main factors. If cavitation plays a part, you'd want the stuff evaporated before it hits your compressor wheel. If not, you'd want large droplets so only a small portion of the alcohol is directly exposed to the aluminium and most will just fly past and evaporate further down. Maybe the high impact speed at the tips of your compressor wheel would cause cavitation in larger droplets?

Remember that the evaporation of the methanol is what cools the mixture, once it's gaseous, it's just another gas that you are heating. It makes sense to evaporate it at the point where temperatures are highest. That would be either just before the intercooler, or during the compression stroke inside the cylinder.

Pre-turbo injection gives you wet compression, which has many benefits, a major one being increased volumetric efficiency. Changing the inlet density will also alter the location on the compressor map, which can be good or bad, but needs to be considered.

Liquid methanol is corrosive to aluminum (don't store it in an aluminum tank) but you are not very likely to see actual corrosion with vapor.

There is a lot of information in the forum I linked to earlier.

You will want a pump and a check valve, low pressure is not the way to go. Will siphon or drip without a check valve.


MORE NEWS

  • Siphon systems with pump priming
  • FIRESAFE AND API 607
  • Poor Pump Priming - Tapflo
  • Propane Refrigeration Circuit
  • Shanghai MeiYan Yi Pump & Valve Co., Ltd.
    MeiYan Yi diaphragm valve Contact MeiYan Yi
    Shanghai Enine Pump & Valve Co., Ltd.
    Enine diaphragm valve Contact Enine
    Shanghai Saitai Pump & Valve CO., Lid.
    Saitai diaphragm valve Contact Saitai
    Shanghai Fengqi Industrial Development Co., Ltd.
    FengQi diaphragm valve Contact FengQi