Please can someone explain how I can mate a part (ball valve) to a pipe part (created in routing). When I try and mate the part SW brings up a box that says "The selected component is a pipe part. Mat

We are building a high voltage test chamber that will be filled with sulfur hexafluoride (SF6) to prevent arching. The plan for the chamber is to pump it out to around 10^-3 torr or lower (aka higher

We have a need to make some very flat plates from hardened 17-7 PH stainless. The problem we're having is that the plates are ported and ground flat and parallel within 0.001", and we must have a fin

I am working on a motorcycle engine and got into a discussion about how the valve clearances will change as the engine gets hot. It's on an inline 4 cylinder with 5 valve per hole.

I am looking for recommendations for ball valves for isolation of natural gas fuel supply to our power station in the UK. Sizes range from 8inch to 12 inch ASA 300.

Could someone give me some ideas I would like to capture the pulse time for a pulsing input to A PLC, and would like to maitain the time for evaluating untill the next pulse.Just need some help with l

I'll try to briefly describe my problem: My hydraulic circuit (the pumps are supplying 130 bars of pressure) consists of a closed-center proportional valve that drives a hydraulic motor (which is used

We're using a 1.5" peristaltic pump to empty a vertical container in a smooth and stable rate (around 30L/min). What we noticed is a repeatable distortion in the flow rate caused by the peristaltic tu