The holding tank is above the open tank so would like to use a centrifugal pump. Can i use the holding tank extra capacity to create a pump priming circuit? When the open tank is empty (or nearly) to

Can anyone advise on the susceptibility of flexible graphite (trade names "Grafoil", "Papyex" etc.) to explosive decompression (ED) or rapid gas decompression (RGD) in a multi-phase hydrocarbon produc

I have an ethoxylation process with temperature split range control question. First I would like to introduce this process a little bit. The ethoxylation process is to produce non-ionic surfactants an

I have a question about API 600 Standard. I have to issue a Data sheet for Gate Valves 2"-6" (API 600 Standard). If I want a Full port valve, I need to specify this characteristic or all API 600 Gate

I am working on a motorcycle engine and got into a discussion about how the valve clearances will change as the engine gets hot. It's on an inline 4 cylinder with 5 valve per hole. (small valves).

Help.. Where do I go for bolt details above 24"??. ASME 16.5 has only upto 24". I need bolt lengths for 30" class 600 flanged valve connections.

We have a flow control manifold with three parallel branches with two branches having actuated plug valves on them and the third with a manual ball valve on/off. We use this to test centrifugal pumps

I'm currently designing a valve and have been told to use the the B31.3 standard. I have to use a material that will withstand high pressures, but is magnetically soft.