I've just been reading about two-stroke diesel engines. How come there aren't any cars or road vehicles with this type of engine? Also, there are plenty of cars with turbo-diesel engines. Why aren't

There were human factors at play, but a critical pilot operated relief valve was also faulted. I've seen this noted in many reports (Rogovin report) as well as all over the net and unfortunately also

I'm in the process of selecting pneumatic components for a project. The system pressure range is around 1 MPa (10 bar) and the fluid is air. I am a bit confused about which components require CE mark

I am trying to understand what the limits are of pre-compressor methanol injection on turbocharged cars. From my understanding, erosion occurs when you have the wrong combination of compressor speed a

Can anybody clarify the valving/pump arrangement for a pump priming system which then supports the formation of siphon. I am looking for practical examples where this has been employed.

Hopefully somebody can help me answer this question. If it is necessary to use a fire safe ball valve (approved to API 607) on a gas tank as a second closure what approval is required for the 1st clos

I have a problem with the priming of a small Tapflo PTFE double diaphragm pump. It is sat approx half a metre above a drum of 15% Perocetic which it is meant to pump over into a larger container, sitt

I have a refrigeration circuit with three stage compressorThere is an orifice in the bypass line. The line is the feed to the comressor suction KOD. I would like to know the purpose of the orifice.