"A listed outside screw and yoke (OS&Y) gate valve shall be installed in the suction pipe. No valve other than a listed OS&Y valve shall be installed in the suction pipe within 50 ft (16 m) of the pum

My current project is adapting a Garrett AVNT turbo to a gasoline passenger car application with performance in mind. The Garrett AVNT turbo is an electro-hydraulically activated VNT turbo, the pressu

We are looking into installing a Variable Frequency Drive for a Boiler Feed Pump. One of the issue is what to do with the minimum flow valve at the pump discharge.

In this specific case, the fluid is hydrocarbon with a high presence of hydrogen sulfide H2S (up to 160000 ppm). The Owner of the plant defines "Lethal Service" each H2S concentration greater than 100

I am looking to source a shut-off valve for a highly abrasive material,(and I mean highly abrasive).

I am looking at an application where we are using fixed speed gear pumps (Viking) to pump fuel additives to tanker loading bays. The existing system seems completely over-engineered and I would like t

I have experienced something that I consider strange in regular centrifugal compressor operation. I would be grateful if someone of forum members could clarify these issues:

Would a carbon steel valve body (for ball valves) be more suitable or equal to a ductile iron body for a glycol-water based coolant system for cooling a large diesel engine?