You are here:
News
News
Valve material based on pipe material 2010-11-19
I am very new to this industry .. I Humbly request you to advise on valve material selection based on pipe material , I am Factory sales engineer so I always get trouble on this regard.... If you can
PCTFE and RPTFE 2010-11-19
Can someone explain the suitability of RPTFE and PCTFE for ball valve seating?
Can we say that PEEk is the best seat material?
Need a 390 Deg F 2-way control valve w/ electric actuator 2010-11-19
Looking for a 1-1/2" 2-way modulating control valve with electric actuation for a 390 deg F high-temp hot water application. I am only finding pneumatic valves are that temp. Any suggestions
Preventive maintenance of Shutdown Valve (SDV) 2010-11-18
Shutdown Valve (SDV) are used for isolation of process system in case of emergency.
i) Should a preventive measure (PM) apply on SDV ?
Estimate pressure drop/equivalent length on a diaphragm valve? 2010-11-18
To empty a tank on occasion, I'm planning to install a PD pump, pumping about 30-60 gpm of warm water through a 2" line. At the end of the line my circuit will join into a larger 50 psig line. I'll ad
NPSH - Priming - Diaphragm vs Lobe 2010-11-18
I have the following situation and was expecting maybe you can help me out.
Pressure Valve 2010-11-18
I need some assistance on the type of pressure valve I need for a subdivision I am working on. I am a land development engineer in NC, USA.
Double block and bleed valves 2010-11-18
Please could you let me know your opinions or experience on the following task?
